Protectowire 2000 FireSystem Bedienungsanleitung PDF herunterladen (Seite 28)

25

On LED indicator, and Calibration Check/Test

switch are also provided. A programmable

micro jumper located inside the Adapter is

provided so that the user may easily select

either Feet or Meters as the unit of measure-

ment to be digitally displayed.

MFL-92 Fault Locator System

The Fault Locator System is designed to detect

and locate the alarm point (shorted) on the

Protectowire Linear Heat Detector. Unlike the

APL-90 Meter Adapter which determines the

alarm location based upon conductor resis-

tance readings which are subject to variations,

the Fault Locator System is able to locate the

exact location of the actuated section by using

an advanced audio signaling technique.

The MFL-92 consists of two modular units. A

Tone Generator Model FDG-92 and a Tone

Receiver Model FDR-92. Both modules are

housed in durable ABS plastic enclosures

each small enough to be hand carried. Each

module weighs less than 8 ounces (227 g).

The FDR-92 Tone Receiver is powered by one

9 volt Type 1604 battery with an average life of

50 hours. The unit contains a tone signal pick-

up LED indicator and two phone jacks. One

for the exploring Pickup Head and one for an

optional earphone for use in areas where the

ambient noise level is high.

The second module which is the FDG-92 Tone

Generator, is powered by one 9 volt Type

1604A Alkaline battery. Depending upon the

load that the device is connected to, the expect-

ed battery life will range from 4 to 20 hours.

CCoonnvveerrssiioonn FFaaccttoorrss

• 1 inch = 2.54 cm

• 1 foot = 3.05 decimeters

• 1 millimeter = .04 inches

• 1 centimeter = .39 inches

• 1 meter = 3.28 feet

• F° = Degrees Fahrenheit

F° =

9

/

5

C° + 32°

• C° = Degrees Celsius (Centigrade)

C° =

5

/

9

(F°–32°)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare